Once the surface is clean, the new badge can be fitted. If the new badge is self adhesive, remove the backing first. Position the prongs of the badge over the holes in the grommets and then simply push it on. Give it a good firm press, especially if your badge is self adhesive. That is all there is to it.
If your badge does have adhesive, it is advisable to break the adhesion before trying to remove the badge. The easiest way to do this is by using some strong nylon fishing line. Taking a length of line, wrap the ends around each of your hands so as to get a good grip. Ensure that you leave about 15 cm (6inches) in between which you can pull tight. With the line pulled tight and moving it from side to side, try to get the line to slide down between the badge and the surface of the boot or the bonnet. You may have to locate the place where the badge is not such a close fit to do this.
To replace the badge, it is useful to know how it attaches They mostly fit in one of two ways. The vast majority of them have two prongs on the back. One is at the 3 o’clock position and the other is at the 9 o’clock position. These prongs simply push into two plastic grommets that are themselves pushed into holes in the bonnet or boot.
Next, it is simply a case of pulling the badge off. However, it is unlikely that you will be able to grip the edges of the badge. In order to remove the badge sufficiently to grip it, you will need to use a thick, strong cloth and a credit card or similar stiff plastic card. It is advisable that you use a card that is no longer required as the process can damage it.
rasboramislabors 